Tropical Hibiscus

Air Layering Hibiscus: A Propagation Method for Larger Plants

Air layering roots a hibiscus branch while it is still on the parent, giving a larger new plant. Learn when to do it, how to wrap the wound, and when to cut.

On this page
  1. When to air layer
  2. Choose the branch
  3. Make the wound
  4. Wrap in moss and plastic
  5. Check and water
  6. When roots form and when to cut
  7. Potting up
  8. Layering a grafted plant
  9. Good to know

Air layering roots a branch while it is still attached to the parent plant. The rooted section becomes a new plant that starts larger than a cutting would. Do it in late spring or summer, when the plant is growing actively and the weather is warm.

When to air layer

Air layer in late spring to summer, when the plant is growing actively. Temperatures should be above about 21°C (70°F). Roots form more slowly in cool weather.

Choose the branch

Pick a healthy, semi-hardwood branch about 6 to 20 mm (¼ to ¾ in) thick, roughly 30 to 60 cm (12 to 24 in) back from the tip. Avoid soft new growth and old, woody wood.

Make the wound

You can girdle the branch, or make a cut.

  • Girdle. Remove a ring of bark 2.5 to 4 cm (1 to 1.5 in) wide, and scrape off the green cambium layer under it.
  • Slanting cut. Make an upward-slanting cut, and hold it open with a toothpick or a matchstick.

Dust or brush the upper edge of the wound with rooting hormone, such as IBA powder or gel.

Wrap in moss and plastic

Wrap a fist-sized ball of damp, squeezed-out sphagnum moss around the wound. Cover the moss with clear plastic wrap, and tie it tightly above and below. Cover the plastic with foil or dark plastic to shade the developing roots. The moss should be damp, not dripping, because soggy moss can rot the stem.

Check and water

Check the moss every one to two weeks. If it has dried out, add water with a syringe through the plastic. Do not let it become waterlogged.

When roots form and when to cut

Roots usually show in about four to eight weeks, depending on the cultivar and the temperature. Wait until there are several roots, visible through the plastic. Then sever the branch just below the rooted area. Do not cut it free the moment the first root appears.

Potting up

Pot the rooted layer in a small, free-draining container. Leave the moss in place around the roots. Trim about a third to half of the leaves to cut water loss. Keep the new plant in bright shade with high humidity for one to two weeks, then move it into sun gradually.

Layering a grafted plant

If the branch is above a graft, the layer grows its own roots, so it becomes an own-root copy of that cultivar. Some exotic hybrids are weak on their own roots, which is one reason they are grafted, so results vary.

Good to know

  • The method also works on rose of Sharon and other woody hibiscus.
  • It does not harm the parent much, because you are only removing one branch.
  • It is not faster than hibiscus cuttings overall, but it gives a much larger plant at once.

For the seed route, see how to hand pollinate hibiscus flowers. For multicolor and grafted plants, see multicolor hibiscus. For the whole group, see the tropical hibiscus growing guide.

The complete guide to tropical hibiscus

Tropical Hibiscus (Hibiscus rosa-sinensis): Growing Guide
Read the guide

Keep exploring

Guides from other topics

All topics →